Move the telescope in one axis at the given rate.
ASCOM.DriverAccess (in ASCOM.DriverAccess.dll) Version: 3c9121baba46811fe6e53a58a05935662261416d
public void MoveAxis(
Public Sub MoveAxis (
Axis As TelescopeAxes,
Rate As Double
virtual void MoveAxis(
- Type: ASCOM.DeviceInterfaceTelescopeAxes
The physical axis about which movement is desired
- Type: SystemDouble
The rate of motion (deg/sec) about the specified axis
This method supports control of the mount about its mechanical axes.
The telescope will start moving at the specified rate about the specified axis and continue indefinitely.
This method can be called for each axis separately, and have them all operate concurrently at separate rates of motion.
Set the rate for an axis to zero to restore the motion about that axis to the rate set by the Tracking
Tracking motion (if enabled, see note below) is suspended during this mode of operation.
Raises an error if AtPark is true.
This must be implemented for the if the CanMoveAxis(TelescopeAxes) property returns True for the given axis.
This is only available for telescope InterfaceVersions 2 and 3
- The movement rate must be within the value(s) obtained from a IRate object in the
the AxisRates(TelescopeAxes) collection. This is a signed value with negative rates moving in the oposite direction to positive rates.
- The values specified in AxisRates(TelescopeAxes) are absolute, unsigned values and apply to both directions,
determined by the sign used in this command.
- An out of range exception is raised the rate is out of range.
- The value of Slewing must be True if the telescope is moving
about any of its axes as a result of this method being called.
This can be used to simulate a handbox by initiating motion with the
MouseDown event and stopping the motion with the MouseUp event.
- When the motion is stopped by setting the rate to zero the scope will be set to the previous
TrackingRate or to no movement, depending on the state of the Tracking property.
- It may be possible to implement satellite tracking by using the MoveAxis(TelescopeAxes, Double) method to move the
scope in the required manner to track a satellite.