The Rotator type exposes the following members.
Indicates whether the Rotator supports the Reverse method.
Reports True if the rotator and / or driver can perform a sync and False if it cannot.
Set True to connect to the device hardware. Set False to disconnect from the device hardware. You can also read the property to check whether it is connected. This reports the current hardware state.(Inherited from AscomDriver.)
Returns a description of the device, such as manufacturer and modelnumber. Any ASCII characters may be used.(Inherited from AscomDriver.)
Descriptive and version information about this ASCOM driver.(Inherited from AscomDriver.)
A string containing only the major and minor version of the driver.(Inherited from AscomDriver.)
The interface version number that this device supports.(Inherited from AscomDriver.)
Indicates whether the rotator is currently moving
This returns the raw mechanical position of the rotator.
The short name of the driver, for display purposes(Inherited from AscomDriver.)
Current instantaneous Rotator position, allowing for any sync offset, in degrees.
Sets or Returns the rotator’s Reverse state.
The minimum StepSize, in degrees.
Returns the list of custom action names supported by this driver.(Inherited from AscomDriver.)
The destination position angle for Move() and MoveAbsolute().